Spare part for WALTHER steel cartridges.
Long-term use of some Walther steel cartridges wears out the thread on the cartridge. This is manifested mainly by the fact that there is a layer of small brass sawdust in the area of the pressure regulator.
Over time, the thread on the cartridge becomes so worn that the thread does not withstand the air pressure during filling (usually when filling from a pressure bottle) and the entire cartridge "shoots" out of the filling pin.
The advantage of the part we sell is that it eliminates the cause of this problem and at the same time you do not have to buy a new cartridge.
If you do not dare to assemble it, entrust it to your rifleman or order this part, including installation, and we will assemble it for you in our service center.
- Filling PIN for Walther
- 1pc Walther steel cartridge plug
- 1pc Plug seal
Made in Czech Republic